Automobile Accessories User Manual

ManualsBrandsMetra Electronics ManualsAutomobile Accessories95-8153

INSTALLATION INSTRUCTIONS FOR PART 95-8153

APPLICATIONS

LEXUS LS SERIES

1995-2000

NOT FOR USE IN VEHICLES WITH FACTORY

NAVIGATION

KIT FEATURES

• Double DIN Radio Provision

• Stacked ISO Mount Units Provision

A) Double DIN Radio Housing B) Double DIN Brackets

KIT COMPONENTS

TOOLS REQUIRED:

Small Flat Blade Screwdriver/ Panel Removal Tool

• Phillips Screwdriver • Socket Set

1-800-221-0932

TION

www.metr

aonline.com

95-8153

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 95-8153 APPLICATIONS LEXUS LS SERIES 1995-2000 NOT FOR USE IN VEHICLES WITH FACTORY NAVIGATION 95-8153 KIT FEATURES • Double DIN Radio Provision • Stacked ISO Mount Units Provision KIT COMPONENTS A) Double DIN Radio Housing B) Double DIN Brackets A B TOOLS REQUIRED: Small Flat Blade Screwdriver/ Panel Removal Tool • Phillips Screwdriver • Socket Set 1-800-221-0932 www.metraonline.
PAGE 2
95-8153 TABLE OF CONTENTS Dash Disassembly - Lexus LS Series 1995-2000 . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Kit Assembly - Double DIN Radio Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 *Note: Refer also to the instructions included with the aftermarket radio.
PAGE 3
95-8153 DASH DISASSEMBLY LEXUS LS SERIES 1995-2000 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Starting at rear of panel surrounding the shifter carefully pry up and out to remove entire panel including ashtray. (Figure A) 3 Using a panel removal tool or small flat blade screwdriver gently pry out on the top of the A/C vent assembly (including clock) and remove. (Figure B) B 4 Remove (4) screws securing the factory radio/climate control assembly.
PAGE 4
95-8153 KIT ASSEMBLY LEXUS LS SERIES 1995-2000 DOUBLE DIN RADIO STACKED ISO MOUNT UNITS PROVISON Note: Refer also to the instructions included with the aftermarket radio. A 1 Snap the Double DIN Brackets onto the Double DIN Radio Housing. (Figure A) 2 Slide the factory climate controls into the Bracket/Radio Housing assembly aligning the top of the assembly with alignment pins in the bottom of the climate controls and secure using the factory hardware.
PAGE 5
95-8153 FINAL ASSEMBLY FINAL ASSEMBLY A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation.
PAGE 6
95-8153 NOTES 4
PAGE 7
95-8153 NOTES 5
PAGE 8
95-8153 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV.