User Manual

99-3000
3
1. RemovetheA/Cventsfromthefactorydashpanel
byreleasingthespringfasteningclipssecuring
themtothepanel.
2. Mounttheventstotheradiohousingbyinserting
theinneredgeoftheventintothecenterinside
pivotholeandtheouteredgeoftheventintothe
outerpivothole.
3. Usingthesamemetalspringclipsandmounting
proceduresfromtheoriginaltruckpaneltomount
theventstotheradiohousing.(FigureA)
Continue to kit assembly
Kit Preparation
(Figure A)
ISO head unit provision
1. MounttheISObracketstotheradiousingthe
screwssuppliedwiththeradio.(FigureA)
2. SlidetheradiointotheradiohousinguntiltheISO
bracketssnapintoplace.(FigureB)
3. Locatethefactorywiringharnessinthedash.
Metrarecommendsusingthepropermating
adapterfromMetraorAXXESS.Re-connectthe
negativebatteryterminalandtesttheunitfor
properoperation.
4. Reassembledashinreverseorderofdisassembly.
Kit Assembly
(Figure A)
DIN head unit provision
1. SlidetheDINcageintotheradiohousingand
securebybendingthemetallockingtabsoutward.
(FigureA)
2. Slidetheaftermarketradiointothecageuntilit
snapsintoplace.(FigureB)
3. Locatethefactorywiringharnessinthedash.
Metrarecommendsusingthepropermating
adapterfromMetraorAXXESS.Re-connectthe
negativebatteryterminalandtesttheunitfor
properoperation.
4. Reassembledashinreverseorderofdisassembly.
Kit Assembly
(Figure A)
RIGHT SIDE CLIP
right side clip