Installation Manual

99-7523S
Final Wiring and Assembly
Connections to be made to the aftermarket radio:
• Connect the Yellow wire to the 12-volt battery/memory wire.
• Connect the Red wire tot he accessory/ignition wire.
• Connect the Orange wire to the illumination wire. If the aftermarket radio
has no illumination wire, cap off the Orange wire.
• Cap off and disregard the Orange/White wire, it will not be used in
this application.
• Connect the Black wire tot he ground wire.
• Connect the Blue wire to the antenna turn on wire.
• Connect the Blue/White wire to the amp turn-on wire, if the vehicle
also amplified.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the radio’s left rear positive speaker output.
• Connect the Green/Black wire tot he radio’s left rear negative speaker output.
• Connect the Purple wire to the radio’s right rear positive speaker output.
• Connect the Purple/Black wire tot he radio’s right rear negative
speaker output.
Connections to be made to the kit:
1. Plug the 8-way connector supplied with the 99-7523 into Location 1, on the
back of the 99-7523 radio housing (see diagram, on right).
2. Plug the 16-way connector, that was removed from the factory radio, into
Location 2 (see diagram, on right).
3. For manual climate control vehicles only: Plug the 16-way connector
supplied with the 99-7523 into Location 3 (see diagram, on right).
Nota: Automatic climate control vehicles will not use this harness.
4. Reconnect the negative battery terminal and test the radio for proper operation.
5. Reassemble the radio and dash assemblies in reverse order of disassembly.
10