User Manual

5.3
7. Snap the filler bar onto the equalizer housing and
slide the assembly onto the bottom of the radio
housing. (Figure B)
Note: The factory pocket may be used by omitting
this step and mounting the pocket under the radio
housing during installation.
8. Cut and remove all mounting tabs on bracket
Set #1 EXCEPT tabs “B”. (Figure C)
9.
Mount the converted brackets to the back
of the assembly with (6) #8 x 3/4” hex-head
screws supplied.
Continue to kit assembly, p. 5.6
Dodge Raider/Mitsubishi
Montero 1987-1991
1. Remove (2) screws from the top
of the radio trim bezel.
2.
Remove the ashtray and the (2)
exposed screws.
3.
Unclip the radio trim bezel
and disconnect the cigarette
lighter wiring.
4.
Remove the screws securing the
factory radio and disconnect the
wiring. (Figure A)
5.
Snap the filler bar onto the
equalizer housing and slide the
assembly onto the bottom of the
radio housing. (Figure B)
6.
Cut and remove all mounting
tabs on the radio housing
EXCEPT tabs “D”. (Figure C)
Continue to kit assembly, p. 5.6
Eagle Summit (wagon) 1992-1996, Mitsubishi Expo
1992-1995, Plymouth Colt Vista 1992-1994
Dash Disassembly 99-7000
(Figure B) (Figure A) (Figure B)(Figure C)
Mounting tab(s): identified by a
stamped letter on back of tab
“B”
(Figure C)
Mounting tab(s): identified by a
stamped letter on back of tab
“D”
“D”