CD Player - CD Radio Player User Manual

ManualsBrandsMetra Electronics ManualsGame ConsoleLEXUS ES 95-8150

INSTALLATION INSTRUCTIONS FOR PART 95-8150

APPLICATIONS

LEXUS ES SERIES

1992-1996

KIT FEATURES

• Double DIN Radio Provision

• Stacked ISO Mount Units Provision

A) Double Din Trim Plate

KIT COMPONENTS

TOOLS REQUIRED:

Small Flat Blade Screwdriver/ Panel Removal Tool

• Phillips Screwdriver • Socket Set

1-800-221-0932

TION

www.metr

aonline.com

95-8150

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 95-8150 APPLICATIONS LEXUS ES SERIES 1992-1996 95-8150 KIT FEATURES • Double DIN Radio Provision • Stacked ISO Mount Units Provision KIT COMPONENTS A) Double Din Trim Plate A TOOLS REQUIRED: Small Flat Blade Screwdriver/ Panel Removal Tool • Phillips Screwdriver • Socket Set 1-800-221-0932 www.metraonline.
PAGE 2
95-8150 TABLE OF CONTENTS Dash Disassembly - Lexus ES Series 1992-1996 . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Kit Assembly - Double DIN Radio Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 *Note: Refer also to the instructions included with the aftermarket radio.
PAGE 3
95-8150 DASH DISASSEMBLY LEXUS ES SERIES 1992-1996 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the plastic trim piece below the factory radio and remove (2) Phillips screws exposed underneath. (Figure A) 3 Using a small flat blade screwdriver release the clips securing the a/c vent assembly and remove the assembly. (Figure B) 4 Remove (2) Phillips screws inside of vent cavity.
PAGE 4
95-8150 KIT ASSEMBLY LEXUS ES SERIES 1992-1996 DOUBLE DIN RADIO STACKED ISO MOUNT UNITS PROVISON Note: Refer also to the instructions included with the aftermarket radio. A 1 Assemble the climate controls and Double DIN or stacked ISO mount units into the factory brackets using the hardware from disassembly and the screws supplied with the Double DIN or stacked ISO mount units.
PAGE 5
95-8150 FINAL ASSEMBLY FINAL ASSEMBLY A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation.
PAGE 6
95-8150 NOTES 4
PAGE 7
95-8150 NOTES 5
PAGE 8
95-8150 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV.