Installation Instructions

Table Of Contents
386-257-1187
|
iBEAMUSA.com
2
Mirror/Monitor install and wiring
1. Carefully extend the clips on the back
of the clip-on mirror and attach to the
current rearview mirror in the vehicle.
2. Plug the DC socket into the mirror and
run the wire in the path shown in Figure
A and safely hide the wire from being
pulled or caught on while operating the
vehicle.
4. Plug the DC socket into the socket in
the vehicle. There is an additional USB
port on the back of the DC socket so
smart device charging can still be done.
(Figure B)
NOTE: If your vehicle DC socket has power
while the vehicle is powered down, you may
need to unplug the monitor while parked so
the battery does not discharge.
Figure A Figure B
2 Amp Charging port
1
MONITOR INSTALLATION