Installation Guide

REV. 11/10/2020 INST107-CH5
3
(Figure D)
(Figure E) (Figure G)
(Figure F)
KIT PREPARATION
1. Cut and remove the climate vents from
the factory dash panel. (Figure A)
2. Cut the vent area of the factory dash
panel. (Figure B)
3. Secure the extension bracket into the
driver’s side of the dash opening and
secure using factory hardware. (Note the
grabbing clip at the back of the bracket)
(Figure C)
4. Place the vent extension into the factory
vent opening. (Figure D)
Continue to Kit Assembly
Remove shaded area
Remove shaded area