Installation Guide

REV. 11/10/2020 INST107-CH5
5
KIT ASSEMBLY
Pioneer Modular radio provision
Note: For steps 1 and 2, reference the
installation manual provided with the radio
for which hardware to use. The display
screen and radio chassis use two different
types of screws.
1. Secure the radio brackets to the radio
chassis using (4) screws supplied with
the radio. (Figure A)
2. Secure the radio display to the radio
brackets using (4) screws supplied with
the radio. (Figure B)
3. Connect the radio display to the
radio chassis.
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
5. Slide the radio assembly into to the dash,
then secure using the factory hardware
for the passenger side and (1) #8 Phillips
head screw for the driver’s side.
6. Clip the radio trim panel to the factory
dash panel.
7. Reassemble the dash in reverse order of
disassembly to complete the installation.
(Figure A)
(Figure B)