Installation Instructions

ManualsBrandsMetra Manualscar kitsMetra Radio Installation Kit

Metra. The World’s Best Kits.



REV. 1/22/20 INST107-CH3B

INSTALLATION INSTRUCTIONS

107-CH3B

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

• Designed for shallow mount ‡ radios like the Alpine iLX-W650 †

• Brackets included for Pioneer modular radios DMH-C2550NEX and

DMH-C2500NEX †

• Painted scratch resistant matte black to match the factory ﬁnish

† Refer to the radio manufacturer for current models

‡ Radio chassis depth allowed is 3.75”, not including the screen

KIT COMPONENTS

• A) Radio bezel • B) Radio brackets • C) Pioneer adapter brackets • D) Panel clips (4)

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Assembly

- ISO DDIN radio provision .....................................2

- Pioneer Modular DDIN radio provision ..............3

Jeep Wrangler (JL) † 201

8-Up , Gladiator † 2020-Up

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle

specific applications

A B C D

WIRING & ANTENNA CONNECTIONS

Wiring Harness: See metraonline for harness

interface solutions

Antenna Adapter: 40-EU55 (sold separately)

RGB Extension Cable: Pioneer part # CD-RGB150E

(not sold by Metra)

Patent Pending

KIT FEATURES

† Models with a Uconnect® 3.0 radio with 5-inch display

Summary of content (4 pages)

PAGE 1
07-CH3B I N S TA L L AT I O N I N S T R U C T I O N S Patent Pending Jeep Wrangler (JL) † 2018-Up , Gladiator † 2020-Up Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle specific applications † Models with a Uconnect® 3.
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the panel below the steering column. (Figure A) ISO DDIN radio provision 1. Secure the radio brackets to the radio using screws supplied with the radio. (Figure A) 2. Unclip the climate control panel and set aside. (Figure B) 3. Remove (2) Phillips screws securing the radio trim panel, then unclip and remove the panel. (Figure C) 4. Remove (4) Phillips screws securing the radio, then unplug and remove. KIT ASSEMBLY (Figure A) 2.
PAGE 3
KIT ASSEMBLY Pioneer Modular DDIN radio provision 3. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess. Test the radio for proper operation. 1. Secure the radio display to the Pioneer adapter brackets using (6) screws supplied with the radio. (Figure A) Note: Reference the installation manual provided with the radio for which hardware to use.
PAGE 4
107-CH3B I N S TA L L AT I O N I N S T R U C T I O N S If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1187, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.