Installation Instructions

1.800.221.0932
|
MetraOnline.com
2
DASH DISASSEMBLY KIT ASSEMBLY
1. Unclip and remove the panel below the
steering column. (Figure A)
2. Unclip the climate control panel and set
aside. (Figure B)
3. Remove (2) Phillips screws securing
the radio trim panel, then unclip and
remove the panel. (Figure C)
4. Remove (4) Phillips screws securing the
radio, then unplug and remove.
(Figure A)
(Figure B)
(Figure C)
(Figure A)
(Figure B)
ISO DDIN radio provision
1. Secure the radio brackets to the radio
using screws supplied with the radio.
(Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
3. Place the radio into the dash, then
secure using the factory screws.
4. Attach (4) panel clips provided onto the
radio bezel, then attach the bezel over
the radio. (Figure B)
5. Reassemble the dash in reverse
order of disassembly to complete the
installation.