Installation Instructions

REV. 1/22/2020 INST107-CH3B
3
KIT ASSEMBLY
(Figure B)
(Figure A)
Pioneer Modular DDIN radio provision
1. Secure the radio display to the Pioneer
adapter brackets using (6) screws
supplied with the radio. (Figure A)
Note: Reference the installation manual
provided with the radio for which
hardware to use. The display screen and
radio chassis use two different types
of screws.
2. Find a suitable location for the radio
chassis. Route the RGB extension cable
from the radio chassis to the display
screen, then connect it to the
display screen.
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
4. Place the radio display into to the dash,
then secure using the factory screws.
5. Attach (4) panel clips provided onto the
radio bezel, then attach the bezel over
the radio. (Figure B)
6. Reassemble the dash in reverse
order of disassembly to complete the
installation.