Owner's Manual

1.800.221.0932
|
MetraOnline.com
2
1. Unclip and remove the trim panels from
the sides of the center console.
(Figure A)
2. Remove (2) 9/32” screws securing the
padded trim to the center console, then
unclip and remove. Do the same for the
opposite side. (Figure B)
3. Unsnap and remove the u-shaped trim
around the lower dash pocket.
(Figure C)
(Figure D)
(Figure E)
DASH DISASSEMBLY
Remove both sides
4. Remove (2) 9/32” screws securing the
lower portion of the control panel.
(Figure D)
5. Pull the pocket from the top to allow the
upper control panel to pass.
6. For non- NAV models, unclip, unplug,
and remove the control panel. (Figure E)
Continued on the next page
(Figure A)
(Figure B)
(Figure C)