Installation Guide

1.800.221.0932
|
MetraOnline.com
2
1. Unclip and remove the trim behind
the radio. Remove (4) 10mm screws
exposed. (Figure A)
2. Unclip, unplug, and remove the radio
and panel. (Figure B)
3. Remove (4) Phillips screws securing the
factory radio to the dash panel.
(Figure C)
Continue to Kit Assembly
DASH DISASSEMBLY KIT ASSEMBLY
(Figure A)
Bottom chassis radio provision
1. Secure the radio brackets to the radio
using screws supplied with the radio.
(Figure A)
2. Slide the radio assembly into to the dash
and secure using the factory screws.
3. Secure the radio trim panel into the
factory dash panel.
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
5. Reassemble the dash in reverse
order of disassembly to complete the
installation.
(Figure A)
(Figure B)
(Figure C)