User Manual

1.800.221.0932
|
MetraOnline.com
From the main harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the 4-pin harness with stripped leads, to the 4-pin harness on the 52-pin connector.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• If retaining the factory backup camera, connect the Yellow RCA jack to the reverse
camera input.
• If the AUX-IN jack in the dash is desired to be used, connect the Red and White RCA jacks to
the audio input jacks from the aftermarket radio.
• Tape off and disregard the following (2) wires, they will not be used in this application:
Blue/White labeled “500L amp turn on”, Red
• Disregard the DIN jack, it will not be used in this application.
Continue to 3.5mm jack - steering wheel control retention
For models with a factory amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• Connect the Orange/White wire to the illumination (lighting switch) wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (10) wires, they will not be used in this application:
Blue/Pink, Gray, Gray/Black, White, White/Black, Green, Green/Black, Purple,
Purple/Black, Brown
8
CONNECTIONS
(CONT.)