Installation Guide

REV. 11/25/2019 INST108-TO3
5
KIT ASSEMBLY
Note: For steps 1 and 2, reference the
installation manual provided with the radio for
which hardware to use. The display screen and
radio chassis use two different types of screws.
1. Slide the radio chassis between the radio
brackets, then secure using (4) screws
supplied with the radio. (Figure A)
2. Secure the radio display to the radio
brackets using (4) screws supplied with
the radio. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
4. Slide the completed assembly into the
dash, then secure using the factory screws.
5. Snap the radio trim panel over the
completed assembly, then reassemble the
dash in reverse order of disassembly to
complete the installation.
(Figure A) (Figure B)