Specification Sheet

1.800.221.0932

MetraOnline.com

PREFACE

• The 109-UN02 is designed to work with select newer Metra dash kits (sold separately). When

assembling the dash kit, follow the instructions for an ISO DIN radio provision with pocket.

a) The 109-UN02 assembly mount will take place of the pocket provided with the dash kit.

b) The Pioneer radio chassis will take place of the aftermarket radio.

• The 109-UN02 can be installed in many different conﬁgurations to ﬁt many applications,

and can also be customized to take adjustments even further. Careful consideration must

be taken ahead of time before assembling the kit. Items to consider are the angle of the

factory radio and dash, the depth of the radio opening, and items which may be blocked by

the radio display or interfere with it.

• The cable from the radio chassis to the radio display may not be long enough in certain

installations. It is highly recommended to purchase an RGB extension cable from Pioneer,

part number CD-RGB150E.

• Assembly mount: As laid out and shown in Kit Components, the assembly mount will

mount into the lower portion of the dash kit, and the radio chassis will mount above that.

The assembly mount can be ﬂipped 180-degrees to allow more room above in certain

installations where upper sub-dash depth is an issue. There is also play in the mounting legs

to allow depth adjustments into the dash. New holes can also be drilled into the legs to take

this play even further if necessary.

• Display Brackets: Two different brackets are provided to compensate for different dash

angles. If the dash is angled, use the 5-degree brackets. Washers (not provided) can

also be used if more than a 5-degree angle is necessary. The brackets can also be ﬂipped

180-degrees to allow the display screen to sit higher.

• Display Housing: When attaching the display housing to the display brackets, use the

upper mounting holes to place the display screen higher if necessary.