Specification Sheet

REV. 6/2/2020 INST109-UNO2
3
KIT ASSEMBLY
Note: For steps 2 and 6, reference the
installation manual provided with the radio
for which hardware to use. The display
screen and radio chassis use two different
types of screws.
1. Secure the display brackets to the
assembly mount using (4) Allen head
screws provided. (Figure A)
Note: The brackets have a locking pin on
them which must face outwards.
2. Secure the radio chassis to the Metra
dash kit using (4) screws supplied with
the radio. (Figure B)
3. Secure the assembly mount to the
Metra dash kit using (4) Phillips screws
provided. (Figure C)
4. Route the RGB display cable from the
radio chassis, through the opening in
the assembly mount.
5. Complete all instruction steps provided
with the Metra dash kit.
6. Secure the radio display to the display
housing using (4) screws supplied with
the radio. (Figure D)
7. Clip the display trim ring onto the
assembly. (Figure E)
8. Plug the RGB display cable into the
display, then slide and lock in place the
display housing to the display brackets.
(Figure F)
Note: The locking pins can be pulled
back to release the display housing.
(Figure A) (Figure D)
(Figure B) (Figure E)
(Figure C) (Figure F)