Owner's Manual

Connect wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver).
The wire colors of your new receiver may, or may not, match the wire colors of the adaptor. Match adaptor and receiver wires by function, disregarding color.
If your receiver does not have a Dimmer or Illumination wire, tape off the Orange/White wire.
If there is no 12 Volt Constant wire in the factory harness, run wire directly to the battery or
an appropriate fuse.
Connect Ground wire of new receiver to vehicle’s chassis.
Individually tape off any unused wires.
Make final connections following instructions on the next page.
▼▼▼▼▼
STEP 2 -- INSTALL
Plug housings into factory harnesses in vehicle.
Receiver Wiring Adaptor
120 70-5001
Revision 01/22/03
Before starting, compare items on your invoice with items
received. Carefully check through packaging material.
If an item is missing, please call:
Crutchfield at 1-888-955-6000
White - Left Front Speaker Positive
Violet/Black - Right Rear Speaker Negative
Red - 12 Volts Switched Power
Violet - Right Rear Speaker Positive
Green - Left Rear Speaker Positive
Yellow - 12 Volts Constant Power
Gray - Right Front Speaker Positive
Gray/Black - Right Front Speaker Negative
Green/Black - Left Rear Speaker Negative
White/Black - Left Front Speaker Negative
Orange/White - Dimmer
®
Copyright 2003 Crutchfield Corporation
Blue - Power Antenna
STEP 1 -- CONNECT WIRES
▼
*120705001*