Owner's Manual

Receiver Wiring Adaptor

120 70-5002

Revision 09/05/13

Red - 12 Volts Switched Power

Yellow - 12 Volts Constant Power

Black - Chassis Ground

Blue - Power Antenna

STEP 1 -- CONNECT WIRES

Connect wires below to the matching function of each wire on your receiver (refer to instructions

supplied with receiver). The wire colors of your new receiver may, or may not, match the wire

colors of the adaptor. Match adaptor and receiver wires by function, disregarding color.

If your receiver does not have an Illumination wire, tape off the Orange wire. If there is no Ground wire in the

factory harness, connect new receiver’s Ground wire to vehicle’s chassis.

Individually tape off any unused wires.

Make final connections following instructions on page 3.

Power Plug of Harness Set

(see speaker plug instructions on page 2)

*120705002*

Orange - Illumination

Before starting, compare items on your invoice with items

received. Carefully check through packaging material. If an

item is missing, please call

Crutchfield at 1-888-955-6000.

IMPORTANT

PAGE 1
Receiver Wiring Adaptor 120 70-5002 IMPORTANT Before starting, compare items on your invoice with items received. Carefully check through packaging material. If an item is missing, please call Crutchfield at 1-888-955-6000. Revision 09/05/13 STEP 1 -- CONNECT WIRES A. Connect wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your new receiver may, or may not, match the wire colors of the adaptor.
PAGE 2
120 70-5002 Receiver Wiring Adaptor Page 2 STEP 1 -- CONNECT WIRES (continued) E. The speaker plug in this harness set may not be directly compatible with your vehicle’s wiring if the vehicle is equipped with a JBL, or Premium Sound amplifier. An additional adaptor may be needed to correctly interface an aftermarket receiver with a JBL or Premium Sound amplifier. If you have questions, call our Technical Support Department at 1-800-955-9094. F.
PAGE 3
Receiver Wiring Adaptor Connections 120 70-5002 Page 3 STEP 2 -- CONTINUED STEP 2 -- CRIMP CONNECTIONS Tools & Parts Required Wire Stripper/Crimp Tool A. Strip wires back 1/2”. Crimp Caps D. Complete crimp connections for all necessary wires. Generic Illustration E. Be sure to wrap any wires from the Wiring Adaptor that are not necessary (wires with no match from the new receiver) with electrical tape. Receiver Wiring Adaptor Unused Wire (tape over bare wires) STEP 3 -- APPLICATION B.