Owner's Manual

IMPORTANT

Installation Kit

120 92-3042P

Before starting, compare items on your invoice with items

received. Carefully check through packaging material.

If an item is missing, please call:

Crutchfield

Parts Supplied:

Kit Frame

Support Tray

Chevrolet

Revision 09/17/03

Kit assembly instructions are on the following pages.

Page 1 of 3

*120923042P*

Mounting Brackets

Left

Right

(2) Studs

(2) 3/8” Nuts

(4) 1/4” Hex Screws

Trimplate

at 1-888-955-6000

PAGE 1
Installation Kit 120 92-3042P IMPORTANT Before starting, compare items on your invoice with items received. Carefully check through packaging material. If an item is missing, please call: Chevrolet Crutchfield at 1-888-955-6000 Revision 09/17/03 Page 1 of 3 Parts Supplied: Trimplate Kit Frame Support Tray Right (4) 1/4” Hex Screws Left Mounting Brackets Kit assembly instructions are on the following pages.
PAGE 2
Installation Kit 120 92-3042P Chevrolet DIN Receiver Assembly 1. Press posts on trimplate into holes on kit frame to snap parts together and secure with hex screws (Figure 1). 2. Use a utility knife to cut out shaft supports in trimplate to create a DIN opening (Figure 2). 3. Push clips on support tray into slots on rear of kit frame to secure (Figure 1). 4. Select the right side mounting bracket. Break off the tabs that are shown as shaded (Figure 3). 5.
PAGE 3
120 92-3042P Installation Kit Chevrolet Shaft Receiver Assembly 1. Press posts on trimplate into holes on kit frame to snap parts together and secure with hex screws (Figure 1). 2. Push clips on support tray into slots on rear of kit frame to secure (Figure 1). 3. Select the right side mounting bracket. Break off all tabs shown as shaded (Figure 2). 4. Secure mounting brackets to sides of kit assembly with studs and nuts supplied (Figure 1). Nut 5.