Owner's Manual

FIGURE 2

Shaft Supports

Installation Kit

120 92-3042P

Chevrolet

1. Press posts on trimplate into holes on kit frame to snap

parts together and secure with hex screws (Figure 1).

2. Use a utility knife to cut out shaft supports in trimplate to

create a DIN opening (Figure 2).

3. Push clips on support tray into slots on rear of kit frame to

secure (Figure 1).

4. Select the right side mounting bracket. Break off the tabs

that are shown as shaded (Figure 3).

5. Secure mounting brackets to sides of kit frame with studs

and nuts supplied (Figure 1).

6. Remove DIN sleeve from receiver and slide into opening in

trimplate. Secure sleeve to trimplate by bending the

securing tabs (Figure 4).

7. Slide receiver into sleeve/kit assembly.

DIN Receiver Assembly

Securing Tabs

DIN Sleeve

Bend tabs after sleeve

is inside assembly.

FIGURE 1

Trimplate

Kit Frame

Support Tray

Left Mounting Bracket

Stud

Nut

Right Mounting Bracket

FIGURE 3

FIGURE 4

Break off only

shaded tabs

Hex Screws

Right Side

Mounting Bracket

Tools Required

Utility

Knife

▲

Small Flat Blade

Screwdriver

3/8” Socket

Pliers