User Manual

1.800.221.0932
|
MetraOnline.com
2
1. Unclip the top of the steering column,
then unclip and remove the instrument
cluster trim. (Figure A)
2. Remove (1) 9/32” screw securing the
dash trim by the instrument cluster,
then unclip and remove the trim.
(Figure B)
3. Remove (4) 9/32” screws from the climate
control panel, then unclip, unplug, and
remove the panel. (Figure C)
4. Inside a small cavity located behind the
climate control panel, remove (2) 9/32”
screws facing up that are securing the
radio assembly to the dash. (Figure D)
5. Unclip, unplug and remove the radio
assembly.
Note: The (3) top clips securing the
assembly to the vehicle will be reused in
Kit Assembly.
6. For models equipped with OnStar:
Remove the (2) 9/32” screws securing
the OnStar backup battery, then relocate
the module elsewhere in the dash away
from the radio cavity. (Figure E)
7. Remove the module above the OnStar
backup battery location, then relocate
the module elsewhere in the dash away
from the radio cavity. (Figure E)
8. Cut the shaded area in the sub-dash to
allow room for the aftermarket radio.
(Figure F)
Continue to Kit Assembly
(Figure A) (Figure D)
(Figure B) (Figure E)
(Figure C) (Figure F)
DASH DISASSEMBLY