User Manual

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Select 2014-2015 Chevrolet Captiva Sport Vehicles - Matte Black

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

95-3031B

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT FEATURES

• ISO DDIN radio provision

• Painted scratch resistant matte black to match the factory ﬁnish

KIT COMPONENTS

• A) Radio bezel • B) Radio brackets

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• 9/32” socket wrench

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

Wiring Harness: See metraonline for harness

interface solutions

Antenna Adapter: 40-CR10

(sold separately)

Chevrolet Captiva Sport (w nav) 2014-2015

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle

speciﬁc applications

A B

Summary of content (4 pages)

PAGE 1
95-3031B I N S TA L L AT I O N I N S T R U C T I O N S Chevrolet Captiva Sport (w nav) 2014-2015 Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle specific applications KIT FEATURES • ISO DDIN radio provision • Painted scratch resistant matte black to match the factory finish KIT COMPONENTS • A) Radio bezel • B) Radio brackets A TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Assembly..................................
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the trim panel on the top of the dash. (Figure A) 2. Remove (2) 9/32” screws securing the radio trim panel, then unclip and remove. (Figure B) 3. Unclip the entire lower console panel and set aside. (Figure C) 4. Remove (4) 9/32” screws securing the radio. Slide the radio out, then unplug and remove. (Figure A) (Figure B) (Figure C) Continue to Kit Assembly 2 1.800.221.0932 | MetraOnline.
PAGE 3
KIT ASSEMBLY 1. Slide the radio brackets into the radio bezel. (Figure A) 2. Slide the radio between the radio brackets, then secure using screws supplied with the radio. (Figure B) 3. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess. Test the radio for proper operation. 4. Slide the radio into the dash, then secure using the factory screws. 5.
PAGE 4
95-3031B I N S TA L L AT I O N I N S T R U C T I O N S If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1186 ext. 8300, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated.