User Manual

ManualsBrandsMetra Manualschassis components95-7425

METRA. THE WORLD’S BEST KITS.™

APPLICATIONS

1-800-221-0932

metraonline.com

INSTALLATION INSTRUCTIONS FOR PART 95-7425

WIRING & ANTENNA CONNECTIONS (Sold Separately)

Wiring Harness:

• 70-7552 Nissan harness 07-up

• 40-NI12 Nissan antenna adapter 07-up

Antenna Adapter:

• Not Required

Nissan Rogue 2008-2010

95-7425

• Double DIN radio provision

• Stacked ISO mount units provision

Panel Removal Tool • Phillips Screwdriver • Small Flat Blade Screwdriver

A B

• A) Double DIN radio housing • B) Double DIN brackets

TOOLS REQUIRED

KIT FEATURES

KIT COMPONENTS

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 95-7425 APPLICATIONS Nissan Rogue 2008-2010 95-7425 KIT FEATURES • Double DIN radio provision • Stacked ISO mount units provision KIT COMPONENTS • A) Double DIN radio housing • B) Double DIN brackets A B WIRING & ANTENNA CONNECTIONS (Sold Separately) Wiring Harness: • 70-7552 Nissan harness 07-up • 40-NI12 Nissan antenna adapter 07-up Antenna Adapter: • Not Required TOOLS REQUIRED Panel Removal Tool • Phillips Screwdriver • Small Flat Blade Screwdriver METRA.
PAGE 2
95-7425 Table of Contents Dash Disassembly – Nissan Rougue 2008-2010 3-4 Kit Assembly – Double DIN/stacked ISO mount units provision Caution 5 Metra recommends disconnecting the negative battery terminal before beginning any installation. All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition. *NOTE: Refer also to the instructions included with the aftermarket radio.
PAGE 3
95-7425 Dash Disassembly 1. If equipped with center speaker: Unclip and remove the grille (Figure A). Remove (4) Phillips screws securing the speaker. Unplug and remove the speaker. (Figure B). 2. Unclip the panel above the radio including the a/c vents, then unplug hazard switch and remove. (Figure C) Note: If not equipped with center speaker skip step number 2.
PAGE 4
95-7425 Dash Disassembly 3. Unclip the panel below the radio including the climate controls. Unplug climate controls and remove the panel. (Figure D) 4. Remove (4) Phillips screws securing the radio, unplug and remove radio.
PAGE 5
Kit Assembly 95-7425 Double DIN/stacked ISO mount units provision 1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2. Snap the Double DIN brackets to the inside edge of the Double DIN radio housing. (Figure A) 3.
PAGE 6
Notes
PAGE 7
Notes
PAGE 8
REV. 5/13/11 INSTALLATION INSTRUCTIONS FOR PART 95-7425 METRA. THE WORLD’S BEST KITS.™ metraonline.