User Manual

ManualsBrandsMetra Manualschassis components95-7427B

METRA. The World’s best kits.

™

metraonline.com

REV. 7/16/2015 INST95-7427

Installation instructions for part 95-7427

CAUTION!

Metra recommends disconnecting the negative bat

tery terminal before beginning any installation, unless the vehicle

manufacturer recommends against so. Please check with your local

Dealership for more information. All accessories, switches, climate

controls panels, and especially air bag indicator lights must be con

nected before reconnecting the battery or cycling the ignition. Also,

do not remove the factory radio with the key in the on position, or the

vehicle running. It would be best to remove the key from the ignition

and then wait a few seconds before removing the factory radio.

• ISO DDIN radio provision

• PAINTED TO MATCH FACTORY DASH:

95-7427B=BLACK, 95-7427G=GRAY

• Textured To Match Factory Dash

• A) Double DIN radio housing

KIT FEATURES

KIT COMPONENTS

WIRING & ANTENNA CONNECTIONS (sold separately)

Wiring Harness: • 70-7552

Antenna Adapter: • 40-NI12

• Torx screwdriver • Panel removal tool • Phillips screwdriver

TOOLS REQUIRED

Nissan Maxima 2009-2014

(w/o Navigation or Technology Package)

95-7427

Dash Disassembly ................................................. 2

Kit Assembly

– ISO DDIN radio provision ...................................... 3

Table of Contents

Summary of content (4 pages)

PAGE 1
Installation instructions for part 95-7427 Nissan Maxima 2009-2014 (w/o Navigation or Technology Package) 95-7427 Table of Contents Dash Disassembly.................................................. 2 Kit Assembly –. ISO DDIN radio provision....................................... 3 KIT FEATURES • ISO DDIN radio provision • PAINTED TO MATCH FACTORY DASH: 95-7427B=BLACK, 95-7427G=GRAY • Textured To Match Factory Dash KIT COMPONENTS • A) Double DIN radio housing REV.
PAGE 2
95-7427 Dash Disassembly 3. Remove (6) Phillips screws securing the radio. Unplug and remove the radio. (Figure C) 1. Unclip and remove the panel above the radio including the a/c vents and the climate controls. Unplug and remove the panel. (Figure A) 2. Unclip and remove the panel below the radio. (Figure B) PASS AIR BAG 4. Remove (4) Torx head screws securing each side bracket to the factory radio.
PAGE 3
95-7427 Kit Assembly ISO DDIN radio provision 1. Attach the factory brackets and module removed from disassembly to the aftermarket radio with the screws supplied with the radio. Tighten the (2) Torx head screws to the module that were loosened in disassembly. (Figure A) 2. Locate the factory wiring harness and antenna plug in the dash and make all necessary connections to the radio. Metra recommends using the proper mating adapters from Metra and/or AXXESS.
PAGE 4
Installation instructions for part 95-7427 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling. KNOWLEDGE IS POWER REV.