User Manual

ManualsBrandsMetra ManualsAutomotiveMetra 95-8223S Double DIN Installation Kit for 2009-up Toyota Corolla Vehicles (Silver)

METRA. THE WORLD’S BEST KITS.™

APPLICATIONS

1-800-221-0932

metraonline.com

INSTALLATION INSTRUCTIONS FOR PART 95-8223

Toyota Corolla 2009 - up

95-8223/

95-8223S

• Double DIN radio provision

• Stacked ISO mount units provision

• Painted to match factory dash

95-8223 = Black

95-8223S = Silver

Panel Removal Tool • Phillips Screwdriver • Small Flat Blade Screwdriver

A B

• A) Radio Housing Trim Plate • B) Double Din Trim Plate

TOOLS REQUIRED

KIT FEATURES

KIT COMPONENTS

WIRING & ANTENNA CONNECTIONS (Sold Separately)

Wiring Harness:

• 70-1761 - 1987-up Toyota harness

• TYTO-01 - 2003-up Toyota amp interface

Antenna Adapter:

• Not Required

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 95-8223 APPLICATIONS Toyota Corolla 2009 - up 95-8223/ 95-8223S KIT FEATURES • Double DIN radio provision • Stacked ISO mount units provision • Painted to match factory dash 95-8223 = Black 95-8223S = Silver KIT COMPONENTS • A) Radio Housing Trim Plate • B) Double Din Trim Plate A B WIRING & ANTENNA CONNECTIONS (Sold Separately) Wiring Harness: • 70-1761 - 1987-up Toyota harness • TYTO-01 - 2003-up Toyota amp interface Antenna Adapter: • Not Required TOOLS REQUIRED P
PAGE 2
95-8223 Table of Contents Dash Disassembly – Toyota Corolla 2009-up 3 Kit Assembly – Double DIN/stacked ISO mount units provision 4 Caution Metra recommends disconnecting the negative battery terminal before beginning any installation. All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition. *NOTE: Refer also to the instructions included with the aftermarket radio.
PAGE 3
95-8223 Dash Disassembly 1. Unclip and remove the (4) side trim panels from the right and left side of the radio and a/c controls. (Figure A) 2. Unclip and remove the a/c vent panel above the factory radio. (Figure B) 3. Remove (4) 10 mm bolts securing the radio. (Figure C) 4. Remove (8) screws securing the brackets to the factory radio and remove the brackets. (Retain the brackets for re-use during kit assembly.) (Figure D) (Figure B) 5. Remove (4) plastic clips from the back of the factory radio.
PAGE 4
Kit Assembly 95-8223 Double DIN/stacked ISO mount unit provisions 1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2. Attach the clips removed from the factory radio to the back of the radio housing trim plate. (Figure A) 3.
PAGE 5
Notes
PAGE 6
Notes
PAGE 7
Notes
PAGE 8
REV. 5/13/11 INSTALLATION INSTRUCTIONS FOR PART 95-8223 METRA. THE WORLD’S BEST KITS.™ metraonline.