Instructions/Assembly Guide

REV. 5/5/2020 INST95-8733B
3
KIT PREPARATION KIT ASSEMBLY
1. Secure the button panel hooks to the
button housing with (4) #4 x 3/8”
Philips screws included. (Figure A)
2. Assemble the factory buttons into the
button housing and button trim panel
with the (5) #4 x 3/8” Philips screws
included. Note: blanks are included for
different vehicle options. (Figure B)
3. Attach the (2) supplied panel clips to the
radio housing. (Figure C)
Continue to Kit Assembly
1. Route the factory button wiring up to
the top of the dash opening.
2. Attach the radio brackets to the radio
using screws supplied with the radio,
and then secure into the dash opening.
NOTE: the radio mounting screws must
be flush in the brackets so the radio
assembly will fit into the dash opening.
(Figure A)
3. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Re-connect the negative
battery terminal and test the radio for
proper operation.
4. Snap the radio trim panel over the radio
and reassemble the dash in reverse
order of disassembly. (Figure B)
5. Install button assembly starting with the
button panel hooks at the top and then
snapping the bottom in. (Figure C)
(Figure A)(Figure A)
(Figure B)(Figure B)
(Figure C)(Figure C)