Installation Guide

95-3019B
2
Dash Disassembly
1. Unclip and remove the small trim
panel above the factory radio
display, and then remove (2) 9/32”
screws exposed. (Figure A)
2. Unclip and remove the trim panel
below the climate controls that
extend across the dash, and above
the glove box. (Figure B)
3. Unclip and remove the
climate controls. (Figure C)
4. Inside a small cavity located
behind the climate controls,
remove (2) 9/32” screws facing
up that are securing the radio
assembly. (Figure D)
5. Unclip and remove the radio
assembly. (Figure E)
6. Cut and remove the shaded
area from the sub-dash to allow
clearance for the aftermarket radio.
(Figure F)
Continue to Kit Assembly
INSIDE RADIO CAVITY
(Figure A) (Figure B) (Figure C)
(Figure D) (Figure E) (Figure F)