Installation Instructions

386.257.1187
|
MetraOnline.com
2
1. Remove the radio using the Metra
86-9001 radio removal tools. If you do
not have removal tools, the factory dash
panel can be removed with the radio
attached and then the radio can be
removed from the dash.
2. Unsnap and remove the dash panel.
(Figure A)
3. Bend the factory rear support back to
make room for traditional DDIN radios
depth. (Figure B)
4. Cut the pocket out of the factory dash
panel. (Figure C)
Continue to Kit Preparation
(Figure B)
(Figure A)
DASH DISASSEMBLY KIT PREPARATION
1. Place the (4) speed clips into the sub
dash. (Figure A)
2. Attach the (4) supplied panel clips to the
radio trim panel. (FigureB)
Continue to Kit Assembly
(Figure A)
(Figure B)
(Figure C)
Remove shaded area