Instructions

95-7353CH
3
Kit Preparation Kit Assembly
(Figure A)
ISO DDIN radio provision
1. Mount the radio to the radio
brackets using the screws supplied
with the radio. (Figure A)
2. Mount the radio/bracket assembly
into the dash.
3. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
4. Reassemble the dash in reverse
order of disassembly.
1. Mount the a/c vents, storage pocket,
hazard switch, and passenger air
bag indicator into the Radio Housing
Trim Panel using screws removed in
disassembly. (Figure A)
Note: For models without an airbag light,
a blank plate and (3) #8 x 3/8” Phillips
Truss-Head Screws are provided.
2. Mount the start/stop switch or blank
plate depending on your application
into the Radio Housing Trim Panel.
Note: If no switch is present there are
(2) #8 X 3/8” Phillips truss head screws
supplied to mount the blank plate.
3. Install the (8) panel clips removed
in disassembly onto the Radio
Housing Trim Panel.
Continue to kit assembly
(Figure A)
Note: An airbag-light
blank plate and screws
are included for
non-US models.