Installation Guide

1.800.221.0932
|
MetraOnline.com
2
Attention! The factory radio must have the
AM source selected before being removed
from the vehicle.
Attention! A permanent modification to the
center console trim bezel will be required.
The factory radio will no longer be able to be
reinstalled after this modification.
1. Unclip and remove the left and right
side panels from the center console.
Remove (3) T-20 Torx screws from each
side. (Figures A & B)
2. Engage the parking brake then place
the gear selector in neutral. Pull up on
the gear selector boot just enough to
allow the center console trim bezel to be
removed. (Figure C)
3. Open the center console, then starting
from the back, unclip and release the
entire center console trim bezel which
also wraps around the radio. Lift up just
enough to access the connectors from
underneath. Unplug all connectors, then
remove the trim bezel. (Figure D)
4. Remove (2) T-20 Torx screws securing
the cup holders, then slide the cup
holders out and remove them. (Figure E)
5. Remove (4) T-20 Torx screws securing
the radio. Slide the radio out, then
unplug and remove the radio.
6. Dash Modification: Cut the center
console trim bezel to the left and right
side of the bottom of the radio opening,
slightly above the cup holders. These
cuts will have to be perfect as they
will be visible. Cut the trim bezel just
enough to allow room for the kit. It may
be best to leave a little extra, then file
the rest. (Figure F)
Continue to Kit Assembly
DASH DISASSEMBLY (2003-2004)
(Figure A) (Figure D)
(Figure B) (Figure E)
(Figure C) (Figure F)