Installation Guide

REV. 1/15/2019 INST95-8729B
3
Attention! The factory radio must have the
AM source selected before being removed
from the vehicle.
1. Unclip and remove the left and right
side panels from the center console.
Remove (3) T-20 Torx screws from each
side. (Figures A & B)
2. Open both cup holders, then unsnap the
trim covers from each cup holder. Push
the cup holders back in, without their
covers. (Figure C)
3.
Engage the parking brake then place the
gear selector in neutral. Pull up on the gear
selector boot just enough to allow the center
console trim bezel to be removed. (Figure D)
4. Open the center console, then starting
from the back, unclip and release the
center console trim bezel just enough to
access the connectors from underneath.
Unplug all connectors, then remove the
trim bezel. (Figure E)
Note: The trim bezel can also be rotated
90-degrees and left connected.
5. Remove (2) T-20 Torx screws securing
the cup holders, then slide the cup
holders out and remove them. (Figure F)
6. Press in on the (2) plastic clips below the
radio to release the radio. Slide the radio
out, then unplug and remove the radio.
(Figure G)
Note: There are (2) metal tabs on top
of the radio. After the radio has been
released, the radio should drop down
enough for these tabs to clear the dash.
Continue to Kit Assembly
DASH DISASSEMBLY (2005-2008)
(Figure A)
(Figure B)
(Figure C)
(Figure D)
(Figure E)
(Figure F)
(Figure G)