Installation Guide

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certiﬁed technicians

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

95-8729B

If you are having difﬁculties with the installation

of this product, contact our Tech Support line

either by phone at 1-800-253-TECH, or email at

techsupport@metra-autosound.com. Before

doing so, look over the instruction booklet a

second time and ensure that the installation was

performed exactly as the instruction booklet

is stated. Have the vehicle apart and ready to

perform troubleshooting steps before contacting

Metra/Axxess Tech Support.

1. Secure the radio sleeve assembly hardware to the radio using

either the screws supplied with the radio, or the radio screws

provided. Take note that the copper-colored portion of the

assembly is adjustable to allow a perfect ﬁt for the radio to the

kit. (Figure A)

Note: The metal tools shown circled are for removal of the radio

without disassembling the entire dash. (Figure B)

2. Slide the radio sleeve into the radio housing, then secure by

bending the metal tabs down.

Slide the radio into the sleeve/housing assembly until it clicks in.

4. Attach the radio trim ring onto the completed assembly.

Locate the factory wiring harness and antenna connector in the

dash and complete all necessary connections to the radio. Metra

recommends using the proper mating adapter from Metra and/or

Axxess. Test the radio for proper operation

Reassemble the dash in reverse order of disassembly to

complete the installation.

(Figure A)

(Figure B)

KIT ASSEMBLY