Installation Guide

ManualsBrandsMetra ManualsAudioMetra Audi TT 2008-2015 Car Dash Kit

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

95-9114B

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT FEATURES

• ISO DDIN radio provision

• Painted scratch resistant matte black

KIT COMPONENTS

• A) Radio trim panel • B) Radio housing • C) (4) Panel clips • D) (8) ISO screws

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• Socket wrench

• Metra 86-9001 radio removal tools (qty. 2)

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: XSVI-9004-NAV

Antenna Adapter: 40-EU56

A B C D

Audi TT 2008-2015

Visit MetraOnline.com for more detailed information about the product and up-to-date

vehicle speciﬁc applications

Summary of content (4 pages)

PAGE 1
95-9114B I N S TA L L AT I O N I N S T R U C T I O N S Audi TT 2008-2015 Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle specific applications KIT FEATURES • ISO DDIN radio provision • Painted scratch resistant matte black KIT COMPONENTS • A) Radio trim panel • B) Radio housing • C) (4) Panel clips • D) (8) ISO screws A B C D TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Assembly................................
PAGE 2
DASH DISASSEMBLY 1. Insert (4) of the Metra 86-9001 radio removal tools into the slots on the front of the radio face, and then remove the radio. (Figure A) Continue to Kit Assembly (Figure A) 2 386.257.1187 | MetraOnline.
PAGE 3
KIT ASSEMBLY ISO DDIN radio provision 1. Attach the (4) supplied panel clips to the radio trim panel. (Figure A) 2. Attach the radio housing to the radio using screws supplied with the radio. (Figure B) Note: The radio mounting screws must be flush in the brackets so the radio assembly will fit into the dash opening. Screws have been provided in the event they were not provided with the aftermarket radio. 3.
PAGE 4
95-9114B I N S TA L L AT I O N I N S T R U C T I O N S If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1187, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.