User Manual

ManualsBrandsMetra ManualsAutomotiveMetra 98-9306 Single DIN Installation Dash Kit with Heated Switch Relocation Pocket for 2006-Up Select BMW 3-Series (Black) (Discontinued by Manufacturer)

METRA. THE WORLD’S BEST KITS.™

APPLICATIONS

1-800-221-0932

metraonline.com

INSTALLATION INSTRUCTIONS FOR PART 98-9306

BMW 3 series 2006-up

(Not for models with factory navigation)

98-9306

(Used For Heated Seat Models When Using The 95-9306B)

•Relocatesheatedseatswitches

PanelRemovalTool•PhillipsScrewdriver•TorxScrewdriver•SmallFlatBladeScrewdriver

•A)Pocket•B)HeatedSeatSwitchTrimPanel

•C)ExtensionHarness

TOOLS REQUIRED

KIT FEATURES

KIT COMPONENTS

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 98-9306 APPLICATIONS BMW 3 series 2006-up (Not for models with factory navigation) 98-9306 (Used For Heated Seat Models When Using The 95-9306B) KIT FEATURES • Relocates heated seat switches KIT COMPONENTS • A) Pocket • B) Heated Seat Switch Trim Panel • C) Extension Harness A B C TOOLS REQUIRED Panel Removal Tool • Phillips Screwdriver • Torx Screwdriver • Small Flat Blade Screwdriver METRA. THE WORLD’S BEST KITS.™ metraonline.
PAGE 2
98-9306 Table of Contents Dash Disassembly – BMW 3 Series 2006-up 3-4 Kit Assembly – BMW 3 Series 2006-up 5-6 Caution Metra recommends disconnecting the negative battery terminal before beginning any installation. All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition. *NOTE: Refer also to the instructions included with the aftermarket radio.
PAGE 3
98-9306 Dash Disassembly 1. Carefully unclip and remove the shifter trim panel. (Figure A) 2. Remove (4) Torx screws securing the pocket or ash tray assembly to the shifter trim panel. (Figure B) 3. Unclip and remove the heated seat switch assembly from the climate control panel. 4. Remove (5) Torx screws securing the back cover on the heated seat switch assembly.
PAGE 4
98-9306 Dash Disassembly 5. Remove the circuit board and unplug the factory harness.
PAGE 5
98-9306 Kit Assembly 1. Plug the extension harness onto the circuit board. Then reassemble the heated seat switch assembly.
PAGE 6
98-9306 Kit Assembly 2. Clip the heated seat switch trim panel into the pocket. (Figure B) 4. Reattach the 98-9306 pocket assembly to the shifter trim panel using the factory hardware. 3. Clip the heated seat switch assembly into the pocket/trim panel assembly. (Figure B) 5. Route the extension harness through the left side of the dash cavity and plug it into the climate control.
PAGE 7
Notes
PAGE 8
REV. 5/12/11 INSTALLATION INSTRUCTIONS FOR PART 98-9306 METRA. THE WORLD’S BEST KITS.™ metraonline.