User Manual

2
1. Remove (2) Phillips screws from the
top of the driver’s side knee bolster.
2. Remove (2) 7mm screws from the
bottom of the knee bolster.
3. Open the glove box, remove (3) 7mm
screws exposed on the right edge of
the radio trim bezel and remove the
bezel. (Figure A)
4. Remove (2) 7mm screws securing
the left side of the factory radio and
(1) 10mm nut securing the right.
5. Slide the radio from the dash and
disconnect the wiring.
6. Cut and remove all mounting tabs on
the radio housing EXCEPT tabs “A”.
(Figure B)
Continue to kit assembly
Chevrolet Camaro
1993-1996
(Figure A)
1. Unclip the right side of the dash trim bezel.
2. Unclip the left side of the bezel and remove. (Figure A)
3. Remove (3) 7mm hex-head screws securing the factory radio and
disconnect the wiring.
4. Cut and remove all mounting tabs on the radio housing EXCEPT tabs “C”.
(Figure B)
Continue to kit assembly
Pontiac Bonneville
1994-1999
Dash Disassembly 99-3009
(Figure B) (Figure A) (Figure B)
“A”
“C”