Quick Start Guide

1.800.221.0932
|
MetraOnline.com
4
KIT PREPARATION
(Figure A)
(Figure B)
Attention! Due to how involving it is to disassemble
the factory radio, it is highly advisable to read the steps
beforehand to get a clear understanding of what is to be
expected. It would be best if pictures are taken during
the process, and all hardware tagged as the screws are a
different size and shape. If the process seems too complex,
it is best to seek a professional to perform the job. Also
take care when handling the circuit board to avoid static
discharge which will damage the circuit board .
From the factory radio:
1. If not already, turn both climate knobs to the far left .
2. Remove all the Phillips screws securing the cover to the
back of the radio, then unplug and remove the cover
.
3. Remove (8) screws securing the (2) plastic gear
mechanisms. (Figure A)
4. Remove (4) Phillips screws securing the (2) climate
knobs. (Figure A)
5. Press in on (2) tabs to remove each climate knob
from the front. (Figure A)
6. From the front, remove (2) Phillips screws in each
climate knob cavity. (Figure B)
7. Remove the (2) plastic gear mechanisms.
Continued on the next page
3
3 3 3 3
3 3
3
5
5
4
4
5
4
5
4
unit