Quick Start Guide

REV. 4/1/2019 INST99-3028S
7
KIT PREPARATION
(CONT.)
13. Carefully place the circuit board
assembly back into the radio trim panel.
If set in correctly, the (4) locater pins
will line up and push through the circuit
board. (Figure G)
14. Secure the circuit board cover back to
the radio trim panel using the screws
previously removed. (Figure H)
Sub-dash modification:
15. Cut and remove the sub dash radio
support to make room for the interface
and harnesses. (Figure I)
Continue to Kit Assembly
(Figure G)
(Figure H)
(Figure I)
Remove shaded area
Locater pin detail