User Manual

ManualsBrandsMetra ManualsAutomotiveMetra 99-5000 Single DIN Installation Kit for 2000-2006 Lincoln LS Vehicles (Black)

INSTALLATION INSTRUCTIONS FOR PART 99-5000

99-5000

KIT FEATURES

• DIN/ISO Mount Radio Provisions

• Pocket

• A) Radio Housing • B) ISO Brackets • C) Trimplate • D) Mounting Brackets

• E) (2) #8 X 3/8” Phillips Truss Head Screws • F) (4) #8 X 3/8” Phillips Pan Head Screws

KIT COMPONENTS

• Phillips Screwdriver

• Small Flat Blade Screwdriver/ Panel Removal Tool

1-800-221-0932

TION

www.metr

aonline.com

TOOLS REQUIRED:

APPLICATIONS

LINCOLN LS 2000-2006

FORD Thunderbird 2002-2005

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 99-5000 APPLICATIONS LINCOLN LS 2000-2006 FORD Thunderbird 2002-2005 99-5000 KIT FEATURES • DIN/ISO Mount Radio Provisions • Pocket KIT COMPONENTS • A) Radio Housing • B) ISO Brackets • C) Trimplate • D) Mounting Brackets • E) (2) #8 X 3/8” Phillips Truss Head Screws • F) (4) #8 X 3/8” Phillips Pan Head Screws C B E A D F TOOLS REQUIRED: • Phillips Screwdriver • Small Flat Blade Screwdriver/ Panel Removal Tool 1-800-221-0932 www.metraonline.
PAGE 2
99-5000 TABLE OF CONTENTS Dash Disassembly - LINCOLN LS 2000-2006/LINCOLN Thunderbird 2002-2005 . . . . . . . . . . . . 1,2 Kit Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Kit Assembly - DIN/ISO Mount Radio Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
99-5000 DASH DISASSEMBLY LINCOLN LS 2000-2006 FORD THUNDERBIRD 2002-2005 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the A/C vent panel. (Figure A) 3 Remove (2) 10 MM bolts exposed behind vent panel from top of radio brackets. (Figure B) 4 Unclip and remove the panel surrounding the ashtray. (Figure C) B Continued on page 2.
PAGE 4
99-5000 DASH DISASSEMBLY LINCOLN LS 2000-2006 FORD THUNDERBIRD 2002-2005 D 5 Remove (2) Phillips screws exposed behind panel then remove the ashtray assembly. (Figure D) 6 Remove (2) 10 MM bolts from inside ashtray cavity from bottom of radio brackets. (Figure E) 7 Unplug and remove radio/climate control assembly from dash then remove (4) Phillips screws securing the climate controls to the assembly.
PAGE 5
99-5000 KIT PREPARATION LINCOLN LS 2000-2006 FORD THUNDERBIRD 2002-2005 A 1 Secure the Mounting Brackets to the Radio Housing with (2) #8 x 3/8" Phillips Truss-head Screws supplied. (Figure A) 2 Slide the climate control pod into the Radio Housing and secure with (4) #8 x 3/8" Phillips Pan-head Screws supplied. (Figure B) Kit assembly continued on page 4.
PAGE 6
99-5000 KIT ASSEMBLY DIN/ISO MOUNT RADIO PROVISION *Note: Refer also to the instructions included with the aftermarket radio. 1 ISO HEAD UNITS: Mount ISO Brackets to the head unit with the screws supplied with the unit. Slide the head unit into the radio opening until the side clips engage. Snap the Trimplate into the Radio Housing. (Figure A) 2 DIN HEAD UNITS: Slide the DIN cage into the Housing and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage and secure.
PAGE 7
99-5000 FINAL ASSEMBLY FINAL ASSEMBLY A (A) Strip wire ends back 1/2" B (B)Twist ends together (C)Solder (D)Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disassembly.
PAGE 8
99-5000 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV.