Owner's Manual

REV. 5/15/2019 INST99-5719
3
KIT PREPARATION
1. Remove the temperature sensor
assembly from the back of the radio/
climate control panel. Insert the
assembly into the temperature sensor
housing, then secure the assembly
under the dash. Ensure that the vent
opening is not blocked. This is what
monitors the temperature in the vehicle
for the climate control to function
properly.
2. Remove (2) T-10 Torx screws securing the
mounting clips to the sides of the radio/
climate control panel, then remove the
clips. (Figure A)
3. Secure the clips to the radio housing
using the factory T-10 Torx screws.
4. Remove the factory rear support brace
in the sub-dash. (Figure B)
Continue to Kit Assembly
2
Fig. A
Fig. B
Back
wall
Inside edge
of sub-dash
Inside edge
of sub-dash
Back
wall
(Figure B)
(Figure A)