Owner's Manual

REV. 5/15/2019 INST99-5719
7
AUDIO WIRING
This vehicle utilizes a remote radio brain and must
be bypassed to work with an aftermarket radio.
1. Open the trunk, remove (4) pop-clips from the
driver’s side trunk liner, then remove the liner.
(Figure A)
2. Locate the radio brain on the top of the wheel-
well. Disconnect the speaker and antenna
connectors, then connect the wiring harness
provided with the kit to those connectors.
Nothing will connect back to the tuner brain as
it will be bypassed. (Figure B)
3. Route the wiring harness to the radio location
up front, then reassemble the trunk liner and
pop-clips.
4. Please see (4.) on the right:
5. Connect the wiring harness included with the
kit to the wiring harness from the vehicle and
complete all necessary connections to the radio.
Test all functions of the installation for proper
operation, before reassembling the dash .
6. Clip the radio assembly into the dash to
complete the installation.
(located under
the rear deck)
(Figure B)
(Figure A)
(located under
the rear deck)
4. From the wiring harness to the aftermarket radio:
• Connect the Black* wire to the ground wire.
• Connect the Yellow* wire to the battery wire.
• Connect the Red* wire to the accessory wire.
• Connect the Gray wire to the front right positive speaker wire .
• Connect the Gray/Black wire to the front right negative
speaker wire.
• Connect the White wire to the front left positive speaker wire.
• Connect the White/Black wire to the front left negative
speaker wire.
• Connect the Green wire to the rear left positive speaker wire .
• Connect the Green/Black wire to the rear left negative
speaker wire.
• Connect the Purple wire to the rear right positive speaker wire.
• Connect the Purple/Black to the rear right negative speaker wire.
* The Black, Yellow, and Red wires are located on the wiring harness attached to the radio housing.
Radio Brain
Speaker & Antenna Connectors