Installation instructions

KIT COMPONENTS

KIT FEATURES

DIN unit

provision

Equalizer

provision

Pocket

provision

99-5800

INSTALLATION

INSTRUCTIONS

APPLICATIONS

CAR PAGE

FORD

Expedition 1997-98.........................................1-3

F-150 1997-98...................................................1-3

TOOLS REQUIRED

Cutting tool

Socket set

Dremel tool

86-5618 - Head unit

removal keys

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

6 7

Re-connect the battery terminal and test the unit

for proper operation. Snap the head unit/kit

assembly into the sub-dash.

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

Radio Housing

DIN HEAD UNITS: Slide the DIN cage into the Radio Housing and secure by bending the

metal locking tabs outward. Slide the aftermarket head unit into the cage until it snaps into

place.

1-800-221-0932 www.metraonline.com

rev. 4-10-08

PAGE 1
KIT FEATURES 5 DIN unit provision Equalizer provision Pocket provision KIT COMPONENTS DIN HEAD UNITS: Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs outward. Slide the aftermarket head unit into the cage until it snaps into place. 6 A Radio Housing 99-5800 INSTALLATION INSTRUCTIONS APPLICATIONS CAR PAGE FORD Expedition 1997-98.........................................1-3 F-150 1997-98...................................................
PAGE 2
3 ALL VEHICLES Fig. A 1 Dash cavity Fig. B Disconnect the negative battery terminal to prevent an accidental short circuit. Place your index fingers on the inner edges of the a/c vents (shown above) and push inward. Grasp the exposed lip of each vent opening and pull out on the radio trim bezel. Remove the dash trim bezel. (The airbag wiring does NOT need to be disconnected). Using Metra's 86-5618, pull the factory head unit from the dash and disconnect the wiring.