User Manual

1.800.221.0932
|
MetraOnline.com
12
1
2
3
45
6
(Figure A)
Jeep Wrangler 2007-2010
(modifications to radio cavity required)
1. Unclip and remove the lower center trim
below A/C controls. (Figure A)
2. Remove (2) Phillips screws exposed
behind lower center panel. (Figure A)
3. Unclip and remove the upper center trim
starting towards the rear of the panel.
(Figure A)
4. Remove (2) Phillips screws exposed
behind upper center panel. (Figure A)
5. Unclip and remove entire panel
surrounding radio and climate controls,
including A/C vents.
6. Remove (4) 7mm screws securing radio.
Unplug and remove radio. (Figure B)
Note: The top of the metal bracket in
the sub dash will need to be cut to allow
for the clearance of the Double DIN
radio’s chassis.
Continue to Kit Assembly
DASH DISASSEMBLY
(Figure C)
(Figure B)
(Figure A)
(Figure B)
Jeep Wrangler 2011-up
(modifications to radio cavity required)
1. Unclip and remove the power window
switches then remove (1) 9/32” screw
from underneath. (Figure A)
2. Unclip and remove the panel below the
steering column.
3. Remove (2) 9/32” screws from the
bottom edge of the radio/instrument
cluster trim panel on either side of the
steering column. (Figure B, C)
Continued on the next page