User Manual

1.800.221.0932
|
MetraOnline.com
14
DIN radio provision with pocket
1. Remove the metal DIN sleeve from the
aftermarket radio.
2. Slide the sleeve into the radio housing
with pocket and secure by bending the
metal locking tabs outward. (Figure A)
3. Slide the radio into the sleeve until it
clicks in. (Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
5. Reassemble the dash in reverse order
of disassembly.
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
2. Secure the ISO brackets to the radio
using the screws supplied with the
radio. (Figure A)
3. Slide the radio into the radio housing
with pocket until it snaps into place.
(Figure B)
4. Snap the ISO trim plate onto the front of
the completed assembly. (Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
unit for proper operation.
6. Reassemble the dash in reverse order of
disassembly.
(Figure A) (Figure A)
(Figure B) (Figure B)
KIT ASSEMBLY
Right side clip