Manualshelf

Owner's Manual

ManualsBrandsMetra ManualsAudio & Video AccessoriesMetra 99-6514B Single/Double DIN Installation Kit for Select 2011-Up Dodge Charger Vehicles
12345678910
1.800.221.0932
|
MetraOnline.com
6
INSTALL ATION
PROGRAMMING
SCREEN OPERATION
FINAL ASSEMBLY
Attention! For models with a 8-inch screen, update the interface via the Axxess Updater
available at axxessinterfaces.com. Select “8-inch screen” once prompted to. Instructions to
update the interface are available at the end of this instruction booklet.
With the key in the off position:
1. Connect the 16-pin harness with stripped leads, and the 6520 harness, into the interface.
2. Connect the factory “White” 4-pin harness removed in step 5 of Dash Disassembly to the
“Black” connector from the interface.
Note: The display screen will not function without this connection.
3. Connect the 6514 harness to the wiring harness in the vehicle.
4.
Connect the climate control harness from the vehicle to the 99-6514B radio trim panel. This is the
harness that was removed in step 4 of dash disassembly
.
5. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Metra recommends using the proper mating adapter from Metra.
Note: If an ASWC-1 (sold separately) will be used, do not connect it until the interface is
programmed and fully functional.
1. Secure the completed radio assembly to the dash using the factory hardware.
2. Reassemble the dash in reverse order of disassembly using the 99-6514B panel.
1. When the interface first boots up, the factory screen will go through a boot up sequence for
a few moments. Do not touch any controls during this process.
2. Test all functions of the installation for proper operation, before reassembling the dash. For
amplified models, also refer to the “Audio Level Adjustment” section.
Note: Reference the Troubleshooting section for factory items known to be no longer functional.
1. Radio button – Show the current time
2. Player button – Not used in this application
3. Climate button –
Takes you to the climate screen
4. Setting button – Takes
you to the setting screen
5. More button – Shows the outside temperature
and current time
6. Screen Off – Turns the display off
1
2
3
4
5
6
AUDIO LEVEL ADJUSTMENT
For models
with
a factory amplifier:
1. With the vehicle and radio turned on, turn the volume up 3/4 of the way.
2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower the audio level.
3. Once at a desired level, audio level adjustment is complete.