User Manual

99-6525

Axxess Interface Installation

• Provides accessory power (12-volt 10-amp)

• Retains R.A.P. (retained accessory power)

• Used in non-amplified systems

• Provides NAV outputs (parking brake, reverse, and speed sense)

• Prewired ASWC-1 harness included (ASWC-1 sold separately)

• High level speaker input

• Retains balance and fade

• Ability to add aftermarket backup camera and additional video input

• Retains factory screen

• Micro “B” USB updatable

FEATURES

• Cutting tool • Crimping tool • Tape

• Connectors (example: butt-connectors, bell caps, etc.)

TOOLS REQUIRED

• Axxess Interface

• 16-pin harness with stripped leads

• 6525 harness with stripped leads

INTERFACE COMPONENTS

Connections to be made

From the 16-pin harness to the aftermarket radio:

• Connect the (2) Red wires to the accessory wire. Note: If using an ASWC-1 (sold

separately), there will be a Red wire there to connect as well.

• Connect the Orange/White wire to the illumination wire. (If the aftermarket radio

has no illumination wire, tape off the Orange/White wire.)

• Connect the Blue/White wire to the amp turn-on wire.

The following (3) wires are for aftermarket multimedia/navigation radios that provide

these wires (if not required, tape them off and disregard them).

• Connect the Light Green wire to the parking brake.

• Connect the Blue/Pink wire to the VSS or speed sense wire.

• Connect the Green/Purple wire to the reverse wire.

• Tape off and disregard the Brown, White, White/Black, Gray, Gray/Black,

Purple, Purple/Black, Green, and Green/Black wires, they will not be used in

this application. Plug the 16-pin harness into the interface.