Installation Instructions

386.257.1187
|
MetraOnline.com
4
AXXESS INTERFACE INSTALLATION
INTERFACE COMPONENTS
• Axxess interface (built into the touchscreen display)
• 6537 harness
• 16-pin harness with stripped leads
• 4-pin harness with yellow RCA jacks
• Hazard harness
• Female 3.5mm connector with stripped leads
TABLE OF CONTENTS
Connections ................................................................................................................................5-7
For models without an amplifier ...........................................................................................5
For models with an amplifier ................................................................................................. 6
3.5mm jack steering wheel control retention ....................................................................... 7
Installation .................................................................................................................................... 8
Programming ................................................................................................................................ 8
Final Assembly ............................................................................................................................. 8
Touchscreen display operation ............................................................................................... 9-10
Steering wheel control settings .............................................................................................11-12
Troubleshooting ...........................................................................................................................13
INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains audio controls on the steering wheel
• Retains safety chimes
• Retains the factory backup camera
• Retains the factory AUX-IN jack
• Retains balance and fade*
• USB Micro-B updatable
* Non-amplified models only.
TOOLS REQUIRED
• Wire cutter
• Crimp tool and connectors (example: butt-connectors, bell caps, etc.)
or
• Solder gun, solder, and heat shrink
• Tape
• Zip-ties
• Small flat-blade screwdriver