User Manual

99-6537B

Connections to be made (cont.)

3.5mm jack - steering wheel control retention:

The 3.5mm jack is to be used to retain audio controls on the steering wheel control.

• For the radios listed below, connect the included female 3.5mm connector with

stripped leads, to the male 3.5mm SWC jack from the 6537 harness.

Any remaining wires tape off and disregard.

• Eclipse: Connect the steering wheel control wire, normally Brown, to the

Brown/White wire of the connector. Then connect the remaining steering

wheel control wire, normally Brown/White, to the Brown wire of

the connector.

• Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the

Brown wire.

• Kenwood or select JVC with a steering wheel control wire: Connect the

Blue/Yellow wire to the Brown wire.

Note: If the Kenwood radio auto detects as a JVC, manually set the radio

type to Kenwood. See the instructions under changing radio type.

• XITE: Connect the steering wheel control SWC-2 wire from the radio to the

Brown wire.

• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the

AX-SWC-PARROT (sold separately), and then connect the 4-pin connector from

the AX-SWC-PARROT into the radio.

Note: The radio must be updated to rev. 2.1.4 or higher software.

• Universal “2 or 3 wire” radio: Connect the steering wheel control wire,

referred to as Key-A or SWC-1, to the Brown wire of the connector. Then

connect the remaining steering wheel control wire, referred to as Key-B

or SWC-2, to the Brown/White wire of the connector. If the radio comes with

a third wire for ground, disregard this wire.

Note: After the interface has been programmed to the vehicle, refer to the

manual provided with the radio for assigning the SWC buttons. Contact the

radio manufacturer for more information.

• For all other radios: Connect the 3.5mm jack into the port on the radio designated

for an external steering wheel control interface. Refer to the manual provided with

the radio if in doubt as to where the 3.5mm jack goes to.

4-pin harness with yellow RCA jacks:

• If retaining the factory backup camera to the touchscreen display is desired,

connect the Yellow RCA jack labeled “Rearview camera”, to the Yellow RCA

jack from the 6537 harness.

• Disregard the Yellow RCA jack labeled “AUX video”, it will not be used in

this application.

Continued on the next page