User Manual

99-6537B
8
Installing the interface
It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
Touchscreen display
1. Connect the 16-pin harness with stripped leads into port “B” in the touchscreen display.
2. Connect the 6537 harness to the wiring harnesses in the vehicle. Then insert the 6537
harness into port “A” in the touchscreen display. But do not install this harness until exactly
before step 1 of “Initializing the Interface”. This is a timed process
3. Connect the 4-pin harness with yellow RCA jacks into port “C” in the touchscreen display.
4. Connect the hazard harness into port “D” in the touchscreen display, and then to the wiring
harness in the vehicle.
5. Disregard port “E”, it will not be used in this application.
6. Port “F” is an update port for future firmware upgrades.
7. Locate the factory antenna connector in the dash and complete all necessary connections
to the radio. Metra recommends using the proper mating adapter from Metra.
A
B
C
E
F
D
Initializing the interface
Attention! If the interface loses power for any reason, the following steps
will need to be performed again.
1.
Refer to step 2 of “Installing the interface”.
2. Press the push-to-start button to start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type; “Dodge Durango”.
b. Wait until the radio comes on, and the touchscreen display shows
“SWC Configured”. This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn’t come on within 3
minutes, and/or the touchscreen display does not show “SWC Configured”, turn the vehicle
off and disconnect the 6537 harnesses from port “A” in the touchscreen display. Check all
the connections, reconnect the harness into the touchscreen display, and then try again.
4. Test all functions of the installation for proper operation, before reassembling the dash.
Note: The clock and compass in the driver’s information center will no longer be functional.
Final assembly
2. Secure the completed assembly into the upper dash using the factory hardware.
3. Snap the radio trim panel with touchscreen display over the completed assembly, and
then reassemble the dash in reverse order of disassembly.