Owner's Manual

ManualsBrandsMetra ManualsAudio accessories & installationDash Kit

99-7410

INSTALLATION

INSTRUCTIONS

APPLICATIONS

CAR PAGE

NISSAN

200SX 1995-98........................................................1-3

Sentra 1995-99........................................................1-3

KIT COMPONENTS

TOOLS REQUIRED

Cutting tool

Adjustable wrench

Phillips screwdriver

Spacer

Snap Spacers

Equalizer

Dummy Plate

Radio Housing

KIT FEATURES

Shaft and

DIN unit

provisions

Equalizer

provisions

1-800-221-0932 www.metraonline.com

Summary of content (4 pages)

PAGE 1
KIT FEATURES Shaft and DIN unit provisions Equalizer provisions KIT COMPONENTS 99-7410 INSTALLATION INSTRUCTIONS Radio Housing APPLICATIONS CAR PAGE NISSAN 200SX 1995-98........................................................1-3 Sentra 1995-99........................................................1-3 Spacer Snap Spacers Equalizer Dummy Plate TOOLS REQUIRED Phillips screwdriver Cutting tool 1-800-221-0932 Adjustable wrench www.metraonline.
PAGE 2
ALL VEHICLES 1 Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip the dummy plate from the center of the switch panel (above the radio opening). Unclip the radio trim bezel and remove. Remove (4) Phillips screws securing the factory head unit and disconnect the wiring. Remove (2) Phillips screws securing the factory cupholder and remove. 2a Fig. A *OPTIONAL 2-SHAFT HEAD UNITS: Attach the Spacer* to the Radio Housing.
PAGE 3
2b *OPTIONAL Fig. A Fig. C Fig. B DIN HEAD UNITS: For a surface-mount installation, cut and remove the shaft *OPTIONAL supports from the Spacer* and Radio Housing. Place the Spacer into the Housing. Slide the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. A). For an intermediate-mount installation, cut and remove the shaft supports from the Radio Housing.
PAGE 4
"B" "A" "B" "A" Mount the factory cupholder to the bottom of the Radio Housing with (2) Phillips screws previously removed in step #1 ("A") and (2) locating pins ("B"). 5 A 6 B C D A) Strip wire ends back ½" B) Twist ends together C) Solder D) Tape Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit).